Watkins 74427 E5 Circulation Pump - Hotspring w/ 4' Terminated Cord

Description

Watkins 74427 E5 Circulation Pump - Hotspring w/ 4' Terminated Cord
This small circulation pump (Watkins PN 74427 NEW E5 circ. pump) is used in all model HotSpring Spas 1996 to Current. The pump DOES come with a terminating cord set.  We only sell NEW Watkins factory pumps: NO rebuilds.
Replaces the Silent Flo 5000 or earlier models.
HotSpring Spas:
1996 to current
Limelight Spas:
2008 to Current
Tiger River Spas:
all models
Replaces PN 73588 (older version Silent Flo 5000)
Install Instructions included (easy to follow)
Note:
This and all circulation pumps are water lubricated and cooled and require the presence of water at all times. This pump should NOT be operated without water present in the spa. If a “dry run” occurs , the pump has an internal safety device that will automatically shut it down.  To reset this pump simply power down the spa for 30 seconds then power it back up.
Technical Specs:
115volts/ 35 watts (6,000 Gallons every 24 hours)
Removal of old pump
Disconnect power to the spa.
Access the equipment compartment.
Unplug the circulation pump from the control box.
If the spa is filled with water, clamp the circulation pump inlet and outlet tubing with Hose Clamp Pliers or insert wine bottle corks into the ends of the tubing.
Remove the bonding wire and base bracket screws.
Use pliers to slide the spring clamps located on the inlet and outlet fittings back onto the vinyl tubing.
Remove the vinyl tubing from the pump inlet and outlet fittings.
Installation of the new pump
Reverse steps 3 to 7 of the Circulation Pump Removal instructions.
Check for water leaks.
Reconnect power to the spa.
Perform a water flow test.
Check for any air in the plumbing lines. If air does not clear, bleed off the air at the closest tubing clamp.
Reinstall the equipment compartment door.